LEJ2 KYMCO Agility 50 R16, Super 8 50

KYMCO Agility 50 / Super 8 50 CDI (LEJ2)

🔧 CDI Unit · Electronic Ignition Module · 8-Pin Female Connector

For KYMCO Agility 50 R16, Super 8 50 · OEM replacement

This is a CDI unit (model LEJ2) designed for KYMCO Agility 50 R16, Super 8 50, and compatible models. The CDI (Capacitor Discharge Ignition) is the core control component of the engine's ignition system, responsible for sending high-voltage pulses to the ignition coil at the precise moment to ignite the air-fuel mixture.

This unit features an 8-pin female connector and is manufactured to OEM specifications for perfect compatibility with your vehicle's wiring harness. It is the ideal replacement when the original CDI fails, causing ignition problems or starting difficulties.

This CDI unit fits the following KYMCO models:

The CDI (Capacitor Discharge Ignition) is the core control component of the ignition system, directly affecting engine performance:

• Ignition Timing Control: Calculates precise ignition advance based on crankshaft position sensor signals for optimal combustion.
• High-Voltage Pulse Output: Converts low voltage into high-voltage pulses to trigger the ignition coil.
• RPM Limiting: Some CDI units include rev limiters to protect the engine from overspeed.
• Combustion Efficiency: Ignition timing directly affects combustion quality, power output, and fuel economy.

• Hard Starting: Engine is difficult to start or requires multiple attempts.
• Rough Idle: Engine vibrates at idle, unstable RPM.
• Poor Acceleration: Feels underpowered, sluggish response.
• Misfiring: Sudden hesitation during riding, feels like fuel or spark cut-out.
• No Spark: No high-voltage spark at the spark plug.
• Increased Fuel Consumption: Poor ignition leads to incomplete combustion and higher fuel usage.

If you experience these issues, inspect the ignition system components and replace the CDI if necessary.

• OEM Specifications: Manufactured to KYMCO original specifications for perfect electrical matching.
• 8-Pin Female Connector: Standard 8-pin female design for perfect harness compatibility.
• Precise Ignition: High-quality electronic components ensure accurate and reliable ignition timing.
• Direct Replacement: Perfect substitute for damaged or worn original CDI units (OEM 00130005).
• Stable & Durable: Quality components resist heat and aging for long service life.

🔧 Installation Tip

1. Disconnect the negative battery terminal before installation to prevent shorts.
2. Locate the original CDI unit (typically under the seat or on the frame side).
3. Disconnect the 8-pin connector, remove mounting bolts, and take out the old CDI.
4. Install the new CDI, secure with mounting bolts, and connect the 8-pin connector.
5. Ensure the connector is fully seated for good contact.
6. Reconnect the battery and test starting and idle operation.

⚠️ Important Notice: This is a KYMCO Agility 50 R16 / Super 8 50 CDI unit (model LEJ2) with an 8-pin female connector. Compatible with Agility 4T R16, Agility RS 4T, Like 4T, Super 8 4T (2008-2010 models). OEM replacement number: 00130005. Before purchasing, please verify your original CDI has an 8-pin female connector. Images are for reference only. The actual product may vary.