Ball Pin Assy

CFMoto Ball Pin Assembly

OEM: 9RHV-050010-1000-20

Fits CFMoto CForce 110 Series ATV Models

This is an OEM-quality CFMoto ball pin assembly (ball joint), part number 9RHV-050010-1000-20. The ball joint is a critical connecting component of the vehicle's suspension and steering systems, connecting the steering knuckle to the control arms or tie rod. It allows multi-angle rotational movement while withstanding various loads during vehicle operation.

Manufactured from high-quality alloy steel with precision-ground and hardened ball surfaces, combined with POM or nylon bearings, it offers excellent wear resistance and self-lubricating properties, ensuring smooth steering and suspension movement.

• OEM Part Number 9RHV-050010-1000-20: Direct replacement, fully compatible with CFMoto official parts system.
• Precision Ball Surface: Precision-ground ball surface with high sphericity for smooth, bind-free movement.
• Wear-Resistant Bearing: POM (Polyoxymethylene) or nylon bearing provides excellent self-lubrication and long wear life.
• High-Quality Dust Boot: Includes oil and weather-resistant rubber dust boot to prevent dirt and moisture ingress, extending service life.
• Heat Treated: Ball stud is quenched and tempered with surface hardening for high hardness and excellent fatigue resistance.
• Safe & Reliable: Ball housing features a swaging process to prevent ball stud pull-out for safe, reliable operation.

✅ Service Tip: Ball joints are wear-prone components in the suspension system. If the vehicle exhibits heavy steering, pulling, abnormal tire wear, or "clunking" noises when going over bumps, inspect the ball joints for looseness or wear. Check by prying the ball joint connection with a pry bar — if noticeable play is present, replacement is needed. Worn ball joints must be replaced immediately to prevent ball joint separation and serious accidents.

⚠️ Installation Note: Before installation, ensure the tapered hole is clean. Insert the ball stud tapered shaft into the tapered hole and tighten the nut to the specified torque. Ensure the dust boot is properly sealed after installation. A four-wheel alignment must be performed after installation to ensure front wheel parameters meet factory specifications. It is recommended to replace ball joints on both sides simultaneously to ensure even wear.

📑 Part Information Summary:

Ball Pin Assembly (Ball Pin Assy): CFMoto 9RHV-050010-1000-20
Fits: CFMoto CForce 110 (2023-2026) / CForce 110 (2024-2026)

This ball pin assembly fits CFMoto CForce 110 series models — a critical connecting component for the suspension and steering systems, providing OEM-quality reliable performance.