CFMoto CF400NK CF650 Oil Filter

✨ Product Type: Oil Filter

✨ System: Engine Lubrication System

✨ Recommended Replacement: Replace with every oil change

• ENGINE 2017-2021 268MQ FOR CF400
• ENGINE 2019-2021 268MQ FOR CF400-5

• ENGINE 2018-2021 268MQ-A
• ENGINE 2018-2021 268MQ-A FOR CF400-5

• ENGINE 2020-2021 283MU

📌 Important Note: This part is an Oil Filter, part number 0MQ0-070200. The list above represents the full compatibility data based on OEM information. It is recommended to replace the oil filter with every oil change for optimal engine protection. If your engine model is not listed, please verify your original part number or contact our support team to confirm compatibility.

🔧 Preparation

• Ensure the engine is turned off and cooled to room temperature (to avoid burns).
• Prepare tools: oil filter wrench (or strap wrench), drain pan, funnel, new engine oil, and clean rags.
• Place the vehicle on level ground and engage the parking brake.
• Wear protective gloves to avoid contact with hot oil and chemicals.

🔄 Step 1: Drain the Old Oil

• Locate the oil drain plug at the bottom of the engine and place the drain pan underneath.
• Using the appropriate wrench, remove the drain plug and allow the old oil to fully drain into the pan.
• After the oil has stopped dripping, clean the drain plug and sealing washer, then reinstall and tighten to the specified torque.

🧽 Step 2: Remove the Old Oil Filter

• Using an oil filter wrench, turn the old filter counterclockwise to remove it.
• Carefully tilt the filter to avoid spilling residual oil, and place it into the drain pan.
• Clean the filter mounting surface to ensure no old gasket material or debris remains.

✅ Step 3: Install the New Oil Filter

• Remove the new oil filter (0MQ0-070200) from its packaging.
• Apply a thin coat of new engine oil to the gasket of the new filter to ensure a proper seal and ease future removal.
• Position the new filter vertically against the mounting surface and turn it clockwise by hand until the gasket contacts the mounting surface.
• Then, tighten the filter an additional 3/4 to 1 turn using the filter wrench (do not overtighten to avoid damaging the gasket).

🛢️ Step 4: Add New Engine Oil

• Using a funnel, pour the recommended amount and grade of new oil into the oil fill port (refer to the owner's manual).
• Start the engine and let it idle for approximately 1–2 minutes, checking that the oil pressure warning light turns off.
• Turn off the engine and wait a few minutes for the oil to settle back into the oil pan.
• Check the oil dipstick to ensure the oil level is between the minimum and maximum marks, adding oil if necessary.
• Inspect the filter and drain plug for any signs of leakage.

💡 Maintenance Tips

• It is recommended to replace the oil and oil filter according to the maintenance schedule in the owner's manual (typically every 3,000–5,000 km or every 6 months).
• Under severe driving conditions (e.g., dusty environments, short trips, heavy loads), shorten the replacement interval.
• Always use an original-quality oil filter to ensure filtration performance and sealing integrity.
• If the oil pressure warning light illuminates or abnormal engine noises occur, immediately inspect the oil filter and lubrication system.